Draton troughing idlers are use for conveying bulk materials, and are designed and manufactured with troughing angels of 20⁰ and 30⁰ normally. Idlers of 45⁰ trough angle or any other angle are also manufactured as per customer's design and drawings. We can also design manufacture and supply 5 rollers type idlers. Mounting brackets are manufactured out of standard steel sections to have rigidity and stability of the frame. Shafts are manufactured out of Carbon steel bright steel bars suitable for any torsional load and bending movement.

Draton Return Belt Rubber Idlers are used when wet and sticky materials tend to cling to the belt where corrosion resistance is required or where chemical action to iron or steel is involved.

Features:

• Wear Resistance.

• Corrosive Resistance.
• Cost-effective.

Draton conveyor pulleys are manufactured out of heavy gauge steel tubing, best quality ERW/seamless steel tubes and rolled plates duly fitted with carbon steel single piece shafts suitable for torsional load covered with two side of welded plates and heavy hub to suit the shaft dia. The pulleys are rubber lagged with natural synthetic / neoprint material with and without herringbone groove.

Draton return belt idlers are suitably designed to support the return belt to avoid sagging. Continuous Alignment by always tracking the belt to the center of the conveyor, it reduces edge damage, spillage and overall better conveyor belt tracking performance.

• For Belt Width - 450mm to 1800mm
• Abrasive resistant
• Hot-vulcanized rubber cover

Draton flat belt training idlers automatically trains the belt from misalignment and protects the belt edges from damages caused by the same. The action is positive for belt operations

Draton rubber disc idlers are known as Impact Idler fitted with rubber rings made from natural / synthetic / neoprint material. The fixing arrangement and dimension of rings are suitably design for easy replacement and interchangeability which protect the belt by absorbing impact at loading point.